Új hozzászólás Aktív témák

• sztanozs veterán

  #43468

  #43456 Norbika88

  2022-01-20 13:38:10

  Új Válasz

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  

  sztanozs

  veterán

  #43456 Norbika88

  #43456 Norbika88

  For more options and information see
  # http://rpf.io/configtxt
  # Some settings may impact device functionality. See link above for details

  0# uncomment if you get no picture on HDMI for a default "safe" mode
  hdmi_safe=1

  # uncomment the following to adjust overscan. Use positive numbers if console
  # goes off screen, and negative if there is too much border
  overscan_left=24
  overscan_right=24
  overscan_top=24
  overscan_bottom=24

  # uncomment to force a console size. By default it will be display's size minus
  # overscan.
  #framebuffer_width=1280
  #framebuffer_height=720

  # uncomment if hdmi display is not detected and composite is being output
  hdmi_force_hotplug=1
  hdmi_ignore_edid=0xa5000080
  # uncomment to force a specific HDMI mode (this will force VGA)
  hdmi_group=2
  hdmi_mode=4

  # uncomment to force a HDMI mode rather than DVI. This can make audio work in
  # DMT (computer monitor) modes
  #hdmi_drive=2

  # uncomment to increase signal to HDMI, if you have interference, blanking, or
  # no display
  config_hdmi_boost=4
  # uncomment for composite PAL
  #sdtv_mode=2

  #uncomment to overclock the arm. 700 MHz is the default.
  #arm_freq=800

  # Uncomment some or all of these to enable the optional hardware interfaces
  #dtparam=i2c_arm=on
  #dtparam=i2s=on
  #dtparam=spi=on

  # Uncomment this to enable infrared communication.
  #dtoverlay=gpio-ir,gpio_pin=17
  #dtoverlay=gpio-ir-tx,gpio_pin=18

  # Additional overlays and parameters are documented /boot/overlays/README

  # Enable audio (loads snd_bcm2835)
  dtparam=audio=on

  # Automatically load overlays for detected cameras
  camera_auto_detect=1

  # Automatically load overlays for detected DSI displays
  display_auto_detect=1

  # Enable DRM VC4 V3D driver
  dtoverlay=vc4-kms-v3d
  max_framebuffers=2

  # Disable compensation for displays with overscan
  disable_overscan=0

  [cm4]
  # Enable host mode on the 2711 built-in XHCI USB controller.
  # This line should be removed if the legacy DWC2 controller is required
  # (e.g. for USB device mode) or if USB support is not required.
  otg_mode=1

  [all]

  [pi4]
  # Run as fast as firmware / board allows
  arm_boost=1

  Nincs ötletem, lehet megdöglött a hdmi rajta...

  For more options and information see
  # http://rpf.io/configtxt
  # Some settings may impact device functionality. See link above for details

  0# uncomment if you get no picture on HDMI for a default "safe" mode
  ^

  van itt egy felesleges 0 a konfig fájlban

Új hozzászólás Aktív témák