Új hozzászólás Aktív témák

• #39744 draco31 veterán

  Új Válasz 2020-10-31 21:20:52 #39744

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  draco31

  veterán

  # For more options and information see
  # http://rpf.io/configtxt
  # Some settings may impact device functionality. See link above for details
  # uncomment if you get no picture on HDMI for a default "safe" mode
  #hdmi_safe=1
  # uncomment this if your display has a black border of unused pixels visible
  # and your display can output without overscan
  #disable_overscan=1
  # uncomment the following to adjust overscan. Use positive numbers if console
  # goes off screen, and negative if there is too much border
  #overscan_left=16
  #overscan_right=16
  #overscan_top=16
  #overscan_bottom=16
  # uncomment to force a console size. By default it will be display's size minus
  # overscan.
  #framebuffer_width=1280
  #framebuffer_height=720
  # uncomment if hdmi display is not detected and composite is being output
  #hdmi_force_hotplug=1
  # uncomment to force a specific HDMI mode (this will force VGA)
  #hdmi_group=1
  #hdmi_mode=1
  # uncomment to force a HDMI mode rather than DVI. This can make audio work in
  # DMT (computer monitor) modes
  #hdmi_drive=2
  # uncomment to increase signal to HDMI, if you have interference, blanking, or
  # no display
  #config_hdmi_boost=4
  # uncomment for composite PAL
  #sdtv_mode=2
  #uncomment to overclock the arm. 700 MHz is the default.
  #arm_freq=800
  # Uncomment some or all of these to enable the optional hardware interfaces
  #dtparam=i2c_arm=on
  #dtparam=i2s=on
  #dtparam=spi=on
  # Uncomment this to enable infrared communication.
  #dtoverlay=gpio-ir,gpio_pin=17
  #dtoverlay=gpio-ir-tx,gpio_pin=18
  # Additional overlays and parameters are documented /boot/overlays/README
  # Enable audio (loads snd_bcm2835)
  dtparam=audio=on
  [pi4]
  # Enable DRM VC4 V3D driver on top of the dispmanx display stack
  dtoverlay=vc4-fkms-v3d
  max_framebuffers=2
  [all]
  #dtoverlay=vc4-fkms-v3d
  gpu_mem=252

Új hozzászólás Aktív témák