2. Fórumok
  3. PC, mini PC, barebone, szerver
  4. HP ProLiant MicroServer Gen8

Új hozzászólás Aktív témák

  • #666 bon őstag
    Új Válasz #666
    Új hozzászólás
    Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra
    Privát üzenet küldése

    bon

    őstag

    Új iLO firmware érhető el. v2.20-as verzió:

    Változások:

    This version adds support for the following features and enhancements:

    • The Remote Console security settings were moved from the Administration >
    Security > Remote Console page to the Remote Console > Security page.
    • The new Authentication Failure Delay Time setting allows users to
    configure the duration of the iLO login delay after a failed login attempt.
    This setting can be configured on the Access Settings page.
    • The new Authentication Failures Before Delay setting allows users to configure
    the number of failed login attempts that are allowed before iLO imposes a
    login delay. This setting can be configured on the Access Settings page.
    • iLO 4 2.20 and later allows you to install more than one language pack.
    - For iLO 4 2.10 and earlier—You can install one language pack at a time.
    Installing a new language pack replaces the currently installed language
    pack, regardless of the language pack version.
    - For iLO 4 2.20 and later—Language packs are not supported on servers that
    do not have a NAND. Servers without a NAND should continue to use iLO
    4 2.10.
    - iLO 4 2.20 or later requires version 2.20 or later of the iLO language
    pack.
    - When you upgrade from an earlier version of iLO 4 to version 2.20 or
    later, previously installed language packs are deleted.
    - The following language packs are available: Japanese and Simplified
    Chinese.
    • The HP ProLiant Agentless Management Service status is now listed on the
    Information > System Information > Summary page.
    • Trusted Module status is now displayed on the Information > Overview page.
    • RIBCL scripts and the CLP can now be used to send a test trap to test the
    SNMP configuration.
    • Added support for IPv6 in IPMI LAN Configuration Command Parameters.

Új hozzászólás Aktív témák