Új hozzászólás Aktív témák

• #14 bwoay nagyúr bwoay #12

  Új Válasz 2004-09-29 15:22:24 #14

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  bwoay

  nagyúr

  válasz bwoay #12 üzenetére

  Joint-stereo is the default mode for stereo files with VBR when -V is more than 4 or fixed bitrates of 160kbs or less. At higher fixed bitrates or higher VBR settings, the default is stereo.
  
  stereo
  In this mode, the encoder makes no use of potentially existing correlations between the two input channels. It can, however, negotiate the bit demand between both channel, i.e. give one channel more bits if the other contains silence or needs less bits because of a lower complexity.
  
  joint stereo
  In this mode, the encoder will make use of a correlation between both channels. The signal will be matrixed into a sum (''mid''), computed by L+R, and difference (''side'') signal, computed by L-R, and more bits are allocated to the mid channel.
  This will effectively increase the bandwidth if the signal does not have too much stereo separation, thus giving a significant gain in encoding quality.
  
  Using mid/side stereo inappropriately can result in audible compression artifacts. To much switching between mid/side and regular stereo can also sound bad. To determine when to switch to mid/side stereo, LAME uses a much more sophisticated algorithm than that described in the ISO documentation, and thus is safe to use in joint stereo mode.
  
  forced joint stereo
  This mode will force MS joint stereo on all frames. It's slightly faster than joint stereo, but it should be used only if you are sure that every frame of the input file has very little stereo separation.
  
  dual channels
  In this mode, the 2 channels will be totally indenpendently encoded. Each channel will have exactly half of the bitrate. This mode is designed for applications like dual languages encoding (ex: English in one channel and French in the other). Using this encoding mode for regular stereo files will result in a lower quality encoding.
  
  mono
  The input will be encoded as a mono signal. If it was a stereo signal, it will be downsampled to mono. The downmix is calculated as the sum of the left and right channel, attenuated by 6 dB.
  

Új hozzászólás Aktív témák