Új hozzászólás Aktív témák

• #64283 csixy addikt ubyegon2 #64273

  Új Válasz 2018-12-16 19:44:43 #64283

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  csixy

  addikt

  válasz ubyegon2 #64273 üzenetére

  [senki@fatengelyes-pc ~]$ sudo smartctl -a /dev/sdb
  smartctl 6.6 2017-11-05 r4594 [x86_64-linux-4.19.8-arch1-1-ARCH] (local build)
  Copyright (C) 2002-17, Bruce Allen, Christian Franke, www.smartmontools.org

  === START OF INFORMATION SECTION ===
  Model Family: Indilinx Barefoot based SSDs
  Device Model: Corsair CSSD-V32GB2
  Serial Number: 10340061080009870002
  Firmware Version: 2.1
  User Capacity: 32.017.047.552 bytes [32,0 GB]
  Sector Size: 512 bytes logical/physical
  Rotation Rate: Solid State Device
  Device is: In smartctl database [for details use: -P show]
  ATA Version is: ATA8-ACS (minor revision not indicated)
  Local Time is: Sun Dec 16 19:43:03 2018 CET
  SMART support is: Available - device has SMART capability.
  SMART support is: Enabled

  === START OF READ SMART DATA SECTION ===
  SMART Status not supported: Incomplete response, ATA output registers missing
  SMART overall-health self-assessment test result: PASSED
  Warning: This result is based on an Attribute check.

  General SMART Values:
  Offline data collection status: (0x00) Offline data collection activity
  was never started.
  Auto Offline Data Collection: Disabled.
  Self-test execution status: ( 0) The previous self-test routine completed
  without error or no self-test has ever
  been run.
  Total time to complete Offline
  data collection: ( 0) seconds.
  Offline data collection
  capabilities: (0x1d) SMART execute Offline immediate.
  No Auto Offline data collection support.
  Abort Offline collection upon new
  command.
  Offline surface scan supported.
  Self-test supported.
  No Conveyance Self-test supported.
  No Selective Self-test supported.
  SMART capabilities: (0x0003) Saves SMART data before entering
  power-saving mode.
  Supports SMART auto save timer.
  Error logging capability: (0x00) Error logging NOT supported.
  General Purpose Logging supported.
  Short self-test routine
  recommended polling time: ( 0) minutes.
  Extended self-test routine
  recommended polling time: ( 0) minutes.

  SMART Attributes Data Structure revision number: 16
  Vendor Specific SMART Attributes with Thresholds:
  ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
  1 Raw_Read_Error_Rate 0x0000 --- --- --- Old_age Offline - 6
  9 Power_On_Hours 0x0000 --- --- --- Old_age Offline - 489
  12 Power_Cycle_Count 0x0000 --- --- --- Old_age Offline - 807
  184 Initial_Bad_Block_Count 0x0000 --- --- --- Old_age Offline - 11
  195 Program_Failure_Blk_Ct 0x0000 --- --- --- Old_age Offline - 0
  196 Erase_Failure_Blk_Ct 0x0000 --- --- --- Old_age Offline - 0
  197 Read_Failure_Blk_Ct 0x0000 --- --- --- Old_age Offline - 0
  198 Read_Sectors_Tot_Ct 0x0000 --- --- --- Old_age Offline - 4239304818
  199 Write_Sectors_Tot_Ct 0x0000 --- --- --- Old_age Offline - 2197665990
  200 Read_Commands_Tot_Ct 0x0000 --- --- --- Old_age Offline - 90343929
  201 Write_Commands_Tot_Ct 0x0000 --- --- --- Old_age Offline - 38610438
  202 Error_Bits_Flash_Tot_Ct 0x0000 --- --- --- Old_age Offline - 11514836
  203 Corr_Read_Errors_Tot_Ct 0x0000 --- --- --- Old_age Offline - 10661622
  204 Bad_Block_Full_Flag 0x0000 --- --- --- Old_age Offline - 0
  205 Max_PE_Count_Spec 0x0000 --- --- --- Old_age Offline - 5000
  206 Min_Erase_Count 0x0000 --- --- --- Old_age Offline - 533
  207 Max_Erase_Count 0x0000 --- --- --- Old_age Offline - 1156
  208 Average_Erase_Count 0x0000 --- --- --- Old_age Offline - 898
  209 Remaining_Lifetime_Perc 0x0000 --- --- --- Old_age Offline - 83
  211 SATA_Error_Ct_CRC 0x0000 --- --- --- Old_age Offline - 0
  212 SATA_Error_Ct_Handshake 0x0000 --- --- --- Old_age Offline - 0
  213 Indilinx_Internal 0x0000 --- --- --- Old_age Offline - 0

  Warning! SMART ATA Error Log Structure error: invalid SMART checksum.
  SMART Error Log Version: 1
  No Errors Logged

  Warning! SMART Self-Test Log Structure error: invalid SMART checksum.
  SMART Self-test log structure revision number 1
  No self-tests have been logged. [To run self-tests, use: smartctl -t]

  Selective Self-tests/Logging not supported

  [senki@fatengelyes-pc ~]$

• #64280 csixy addikt ubyegon2 #64273

  Új Válasz 2018-12-16 19:22:38 #64280

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  csixy

  addikt

  válasz ubyegon2 #64273 üzenetére

  Köszönöm az avanzsáltatást!

  Anyyira huncutul lett a telepítés, hogy a benti winnyóz a kingstonon UEFI-s , az USB-re meg legacyban MBR-re lett teleptve az arch.

Új hozzászólás Aktív témák