Aktív témák

• #316 Oliverda Topikgazda

  2011-01-09 00:31:39 #316

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  Oliverda

  Topikgazda

  Shutdown command

  Port 445

  Check out if TCP port 445 is open in the Window's firewall of the target computer.

  * Go to Start/Settings/Control Panel/Security Center
  * Then click on Windows Firewall and then go under the exceptions tab
  * Normally there a line "File Sharing and printers", select it and press OK
  * If you do not have the line, click on Add Port .. and choose the TCP port 445
  * Then go to Start/Settings/Control Panel/System in the Remote tab, check Allow users to connect remotely to this computer.

  Command line

  net use command

  To obtain the necessary rights to run a shutdown command on the target machine, you must first run the net use command. Remember to note down the address of the target machine,it will be needed for the commanf .

  * Go to Start: Run or use the keyboard shortcut: Windows + R
  * Type cmd and OK.
  * A DOS window (command prompt) appears, enter the following command: net use \\ip_target_machine

  Enter the username/password of an administrator session of target computer
  You will receive a message: The command has been successfully executed!

  shutdown command

  From now on we will implement the shutdown command

  The command is as follows (e.g):

  shutdown -s -f -t 30 - m \\192.168.3.4

  * -s: Turns the computer off. (Required)
  * -f: Force running applications to close without warning.
  * -t xx: Set a countdown in seconds
  * -m \\xxx.xxx.xxx.xxx : the IP address of the target computer.

  The GUI available by typing: shutdown -i

Aktív témák